吉祥棋牌

TEL:0577-67319905
News
Current position : Home > Maintenance method for the maintenance of the spindle motor of the woodworking engraving machine

Maintenance method for the maintenance of the spindle motor of the woodworking engraving machine

The spindle motor is an important part of the woodworking engraving machine, and is one of the more vulnerable parts. So, usually need to pay attention to the maintenance and maintenance, to ensure the normal operation and to extend its service life. Maintenance method for the maintenance of the spindle motor of the woodworking engraving machine:
1, master the operation of the spindle motor.
2, the establishment of a good care of the consciousness, forming the end of processing to clean up the habit of spindle motor.
3, keep the air of the electric spindle dry clean.
4, the daily cleaning of the spindle motor, need to remove the electric spindle from the engraving machine, and then use the trachea to the main shaft of the cooling chamber of the residual water, to keep the internal clean. In the short term, the surface of the electric spindle can be coated with anti rust oil, and the shaft end and protective device is kept in the dry place.
5, is not used for a long time and need to seal the electric spindle, restart, in addition to gasoline to clean the surface of the oil and rust, also need to do the following work:
Oil mist 3-5min. Then twist the shaft with the hand, ask for no card.
Check insulation with Ohm meter.
The power supply is switched on, idling, no abnormal.
According to the spindle speed is different, choose different grease, high speed grease or oil mist lubrication.
Tel:0577-67319905
Fax:0577-67319095
Zip:
Add:Yongjia County Oubei town of Wenzhou City Anfeng Industrial Zone
浙ICP备05088850号-1 Copyright@ 2013 Yongjia County, China carving machine manufacturing Co., Ltd. All Rights Reserved Technical support 温州中网   
河北11选5 河北11选5走势图 爱乐透彩票 吉祥棋牌 爱乐透彩票 青龙棋牌下载 爱乐透彩票官网 河北11选5走势图 河北11选5走势图 河北11选5开奖结果